In development · Waitlist
Bluetooth in your iPod Video, without replacing it
A kit for the iPod Video (5th and 5.5th generation). The logic board, screen, click wheel and the iPod's own software all stay. The kit adds Bluetooth, USB-C and room for a bigger battery, with an SD card in place of the hard drive. Everything except the USB-C strip fits without soldering.
- Fits 5G and 5.5G
- Solder-free except USB-C
- The iPod's own menus and playlists stay
Why a kit and not a new logic board
The iPod already gets most things right
Some mods replace the whole logic board and write new software from scratch. That brings a lot of new features, but you lose what the iPod already does well: Apple's menus, Cover Flow, ratings and playlists, and syncing with Music, iTunes or Rockbox if you run it.
Our kit sits alongside instead. The audio is taken after the iPod's own audio circuit and sent wirelessly. The iPod does not know the kit is there, so it works as before, just without the cable.
The kit connects to the iPod's own connectors through thin interposer flexes: one at the battery and one at the headphone jack. No wires to solder on the logic board. Only the USB-C strip, which replaces the 30-pin connector, is soldered.
What you get
What changes, and what does not
Bluetooth
To AirPods and any other Bluetooth headphones or speakers. Plug in wired headphones and the sound goes there as usual.
Light in the headphone jack
A small LED shines through the jack's white plastic. Blue blinks while pairing, green when connected, red when the battery is low.
The hold switch pairs
Flip hold off and on twice within a second and the kit enters pairing mode. No new holes or buttons in the case.
USB-C for charging and sync
The strip sits centred in the 30-pin opening, so the USB-C bezels others have designed for 3D printers fit. Both charging and data.
Bigger battery and SD card
The board sits on top of a 3800 mAh battery in the hard drive bay. An SD card replaces the hard drive.
Sleeps by itself
Bluetooth switches off completely when the iPod is not playing and wakes when you click the wheel. The target is under 20 µA asleep, so the battery does not drain in a drawer.
Fitting
A screwdriver, an opening tool and a soldering iron for USB-C
Open
Pry off the back with a plastic opening tool. Take out the hard drive and the old battery.
Connect the flexes
The battery adapter goes in the battery connector and the interposer between the headphone jack and the logic board. Both snap into the iPod's own connectors.
Drop in the kit
The kit sits on top of the new battery, antenna towards the plastic front. The flexes go into the kit's connectors.
USB-C
Solder the strip in place of the 30-pin connector. If you would rather not solder, we can do it.
Where we are
Join the waitlist
The flexes and the USB-C strip are drawn; the battery adapter and the interposer are going to the factory. The main board will be laid out once the hard drive bay measurements are done. There is no price or ship date yet. The list decides how big the first batch is and whether we open pre-orders.